Indesit washing machine motor does not turn on

Indesit washing machine motor does not turn on A washing machine today is a necessary household item and its breakdown is a tragedy. When the Indesit washing machine engine does not turn on, this does not always mean that the problem lies with it. There may be a lot of reasons, but let’s not guess at the tea leaves, but let’s start identifying the problem.

From simple to complex

The first step is to check the machine parts, inspection of which does not require disassembling the body. A novice master would act differently - if the motor does not work, then the problem is most likely in the brushes. But as practice shows, this is not always the case.

If everything possible on the outside has been checked, then you can climb inside. First, let's check whether the water pressure is sufficient. If not, then there may not be enough water in the tank and the powder added to the tray will not go completely out. After checking the pressure, you need to turn your attention to the valve inlet; there is a filter mesh installed there, which may be clogged.

By cleaning the filter, it is likely that the car will come back to life. The fact is that the Indesit washing machine does not start washing if the water level is insufficient. At the same time, it is not always possible to determine what the problem is by the error code; sometimes it simply does not exist and it is not possible to understand what happened. how to clean the mesh filter

The next possible problem is hidden near the hatch. The hatch door does not fit tightly to the gasket of the machine and therefore the system may not start the engine. You can press the door as hard as you like, but it won’t help. The problem may be in the mechanism itself.

You need to check the mechanism of the door itself and the UBL.

After checking the door, let's look under the top cover, where the pressure switch is located.A blockage may cause the motor to not work. And is everything okay here? Go ahead. We should check the temperature sensors and all wiring for creases and other damage.

Let's check the electric brushes

If the motor does not work for mechanical reasons, then the reason is most likely the brushes. They are probably worn out to the max.

The first thing you need to do is disconnect the car from the power supply and if it is in a dark place (as a rule, cars always stand there) pull it out into the light so as not to shine a flashlight.
Unscrew the bolts on the back wall of the washing machine and remove the cover.
Holding the belt with your hand, remove it and turn the drum pulley with your free hand.
The engine is mounted on bolts, which also need to be unscrewed.
Having removed the engine, we remove the wires from it, but do not forget to photograph their location, then it will be difficult to put them in place.
Finally we got to the carbon brushes. They are arranged in pairs and if at least one of them is worn out, then we throw out the pair and put new ones in their place.

After reading the manual, hold off on buying new brushes; it’s likely that the old ones are still usable.

Testing the module

If all stages were successful and no problems were identified, then we proceed to the last one. The control module is the brains of the washing machine. If you turned on the machine after inspecting the inside, immediately turn it off and open the top cover of the washing machine. There was a breakdown of the Indesit electronic module

While pressing the latch in the center, pull the dispenser tray towards you. Below it are the bolts holding the panel. On a disconnected panel, you need to at least visually determine whether there are any defects, such as melted parts or tracks leading to them. Check to see if the board itself smells burnt.If no visible defects are found, then it is best to take the board to a professional technician, even if you really want to figure it out yourself.