Error D07 in a Brandt washing machine

For unknown reasons, the self-diagnosis system of Brandt washing machines leaves much to be desired. In particular, the error codes do not actually coincide with the problems indicated in the instructions, and in reality they indicate completely different breakdowns. For example, error D07 in a Brandt washing machine supposedly indicates a problem with the door or UBL, but experienced users have already noticed that the matter is completely different. And what to do in this case?

Where to look for the correct decoding?

As mentioned above, looking for a description of the fault code in the instructions or user manual is almost useless. Information can be either true or completely false. But don’t call a technician every time you can’t determine the cause of a breakdown using the code yourself. Then forums on the Internet come to the rescue, where people share their observations. If we are talking about error code D07, then first of all you need to check not the hatch and everything connected with it, as stated in the instructions, but inspect the engine brushes.

Why? The thing is that specifically in Brandt machines, the build quality of the engine and the quality of the brushes themselves suffer. Often after 6-7 months they become unusable. If they really are the problem, buy new ones and replace them. And if not, start diagnosing the door.

Description of the work progress

Do not forget that the motor runs on electricity, so before dismantling it, disconnect the SM from the power supply. Then you need to very carefully disconnect the engine from the tank; to do this, remove all wire contacts.

Important! Remember what you do step by step, or even better, record it in any convenient way.This will help in the future to assemble the car correctly, not to mix up the parts and not miss anything.

Before you start replacing brushes, make sure they need it. Look at the rods. The main problem is that the rods wear out and wear unevenly. The brush must be replaced when the length of the handle is 1.5-2 centimeters. If some elements are almost intact, do not touch them, change only those that are really out of order. Be prepared for the fact that you may need to repair the engine more often than once every six months.

Also take a photo or sketch how the brushes are inserted into the grooves, namely: seating depth, bevel direction, etc. This is important, since if assembled incorrectly, the motor may spark after connecting to the network.

Since you are dismantling the motor to replace the brushes anyway, inspect the internal commutator as well. It happens that dirt settles there, or small scratches appear. These defects must be eliminated. Take a rag or dry brush and brush off the dust; scratches can be easily sanded off with a piece of sandpaper.

Now you can begin installing new parts. The brushes are attached to self-tapping screws. Once again, carefully check that everything is installed correctly. If everything is in order, proceed to reassemble your home assistant using the previously recorded data. Don't forget to put the wiring back in place and attach the motor to the washer tank. Now it's time to test your work in one of the following ways:

• set the wash cycle to idle, turning on the spin cycle;
• run several quick wash cycles.

Note! For the first 10-12 washes, try not to put heavy, bulky items in the drum, since at first the brushes should get used to each other, “get used” to the place, and only then you can use your Brandt washing machine to the maximum.

Don’t forget to periodically inspect the condition of your motor, clean and lubricate it if necessary, and also carry out minor repairs yourself. After all, it is easier to prevent a breakdown than to fix it, and then error D07 will definitely not bother you anymore.

1 reader comment

1. 08/04/2020 at 14:11

   Dmitriy:

   Hello! Can you give me some advice on how to get to the brushes? I was able to unscrew one, but the second does not have access to the screw - it is blocked by the engine mounting element. I wanted to remove the engine, but I couldn’t get to all the mounting bolts.

   Answer