Checking the bearing on a Samsung washing machine

Checking the bearing on a Samsung washing machine Damage to the bearing in the washing machine is a fairly common breakdown that you can handle on your own without the help of a specialist. But before repairing, you should always check the bearing on a Samsung washing machine, because this will save significant time if it later turns out that the bearing assembly is normal, and you disassembled the “home assistant” in vain. We'll tell you how to diagnose this element before starting restoration.

How can you tell if a bearing is worn out?

Checking the bearing assembly without completely disassembling the washing machine is almost impossible, at least if you do not have many years of experience in repairing household appliances. This is due to the fact that bearings at the initial stage of destruction practically do not signal their imminent failure, so most likely you will still have to disassemble the Samsung washing machine. However, there are a number of peculiar signals that you should pay attention to in order to detect a problem in the bearing assembly in advance.

The appearance of extraneous sounds during the operating cycle of the automatic control system. It is almost impossible to detect a strange noise during the spin cycle, given the overall high noise level, but during washing and rinsing it is easy to hear extraneous sounds. Most often this is a grinding sound, an uncharacteristic knocking and strange metallic sounds.
Poor quality spin. Due to the fact that the drum cannot rotate at the speed specified by the user, things will also not be able to effectively get rid of excess moisture.
Excessive vibration during operation.Due to damaged bearings, the machine begins to suffer from poor balancing. As a result, the equipment begins to sway more and even bounce in place.

It is not always the case that when the bearings fail early, the washing machine begins to suffer from strong vibration, because the imbalance can be insignificant, almost invisible to the naked eye.

Damaged rubber seal. If during diagnostics you find damage to the rubber, this may also be an indirect signal that the bearing assembly is not in order.

There is another way to check the bearings, for which you need to disconnect the device from the power supply, open the hatch, press the upper part of the drum with your finger and shake it. The point is that the drum must move synchronously with the tank without play. If during this test you feel unbalanced, then with almost one hundred percent probability the bearing assembly has begun to collapse.

After the first check, you need to strongly spin the drum with your own hands. If it spins freely and makes a slight hum, then everything is fine. But if the movement of the drum is accompanied by a lot of noise, and the drum itself rotates unstably, then this is another reason to buy new bearings and install them instead of the damaged ones. Most often, the element fails during active use, but manufacturing defects cannot be ruled out.

We make sure that the part is faulty

The following instructions are relevant for situations where the initial check did not produce results, so you need to disassemble the Samsung washing machine. This should only be done if the warranty period has already passed, so you no longer face the risk of voiding the warranty due to disassembly of the equipment.However, within the framework of this instruction we will not touch on disassembling the drum, because this is an exceptional situation that should be resorted to only as a last resort. What should I do to check the bearing assembly?

Disconnect the “home assistant” from all communications.
Move away from the wall to provide easy access to the entire CM body.
Remove the back panel.
Examine the tank, mainly its rear part, for which you will have to remove the drive belt.

During the inspection, you need to pay attention to the current lubrication, as well as rusty smudges - all this signals the destruction of parts, during which oil often leaks out profusely. If you see such serious signs of damage to the bearing assembly, then it is better to leave the machine disassembled and not use it until you change the bearings. Do not under any circumstances attempt to wash items while the bearings are faulty, as this is very dangerous.