How to remove the cover of an Indesit washing machine?

To fix even the smallest problem, you will have to remove the top cover of the Indesit washing machine. This is not difficult to do, but a novice master may have problems. It’s easier and cheaper not to run to a service center for every little thing, but to learn how to deal with partial disassembly of the unit on your own. We’ll tell you in the article how to act and what to fear.

Difficulties to be faced?

Most washing machines have no problems with removing the lid - the panel opens easily and without unnecessary effort. But on Indesit models, this task is sometimes very difficult and risky. The fact is that the part is held in place by molded plastic latches. The latter are so tight that they often break and only aggravate the situation. You must not allow the latches to break off - otherwise you will not be able to return the plastic piece to its place.

Before any manipulations to disassemble the washing machine, turn off the power to the equipment and disconnect it from the water supply.

The second danger lies in a banal failure to comply with safety regulations. But everything is simple here: before any manipulations, the machine must be de-energized and disconnected from the water supply.

Removing the cover on the front model

The procedure largely depends on the type of washing machine model. So, to open the top cover of an Indesit front-loading washing machine, you need to remember that the latches are tight and act carefully. Then you will be able to avoid problems and not make the situation worse. But for this you need to not deviate from the instructions.

1. Find two screws on the back panel that hold the top cover.
2. Unscrew the bolts using a Phillips screwdriver.

It is strictly forbidden to pry the cover with a screwdriver or a knife - the plastic latches will break.

3. Come from behind and, lifting the back of the cover, pull it towards you until the latches “operate”.
4. If the lid does not budge, you need to change tactics: go in from the front, press on the top of the plastic and push it towards the back wall.

The main mistake when opening the lid on Indesit washing machines is trying to pry the panel off from the side or front with a knife. Such an initiative will not help with withdrawals, but will create unnecessary problems. The fact is that the latches with such intervention are immediately damaged and broken. Of course, this will help to remove the part, but it will not be possible to return it to its place. It’s better not to rush and try to outsmart the system. Use a screwdriver only to unscrew screws, and do the rest by hand.

Removing the cover on a vertical model

Owners of Indesit top-loading washing machines have a slightly more difficult problem. If the laundry hatch is on top, then when disassembling the machine you will have to remove not only the cover, but also the dashboard. But first you should decide on the purpose of the intervention: if you only need the hatch door, then just unscrew a couple of latches. While the top panel is removed only together with the control mechanism. To avoid any difficulties with a complete analysis, we recommend following the following instructions.

1. Unscrew the screws from the back on both sides of the housing directly under the dashboard.
2. Tilt the panel forward and remove it, carefully unhooking the module from the washing machine body.

Be careful with the wires connected to the control panel.

3. Unscrew the screws holding the cover located under the dashboard.
4. Remove the cover.

Despite the existing tight latches and the need to remove the dashboard, it is not difficult to deal with the cover of Indesit cars. The main thing is to remember safety precautions and act carefully and persistently.

Reader comments

• Share your opinion - leave a comment