How to remove the lid from a top-loading Indesit washing machine?

How to remove the lid from a top-loading Indesit washing machine Sometimes, during repairs, it is necessary to remove the cover from the Indesit top-loading washing machine. If on the “front-mounted” it is enough to unscrew 2 bolts, slightly move the cover back and lift it up, then the “vertical” provide for an order of magnitude more actions. Let's figure out how to dismantle the lid on vertical type automatic machines.

Instructions for removing the cover

To disassemble the lid of the Indesit vertical washing machine, you need to prepare a Phillips and slotted screwdriver. No additional tools are required. It is advisable to study the diagram of your SMA model before disassembling; this will give you an idea of the location of the main components and fastenings of the automatic machine. In principle, you can do without this information.

The algorithm of actions will be as follows:

turn off the power to the washing machine;
pull out the machine to have free access to its rear and side walls;
disconnect the control panel, otherwise you will not be able to remove the top cover of the case. To do this, unscrew the two bolts securing the panel; they are located on the sides of the element. It is important not to damage the plastic latches when removing the panel;
Move the control panel aside. If it interferes with your work, disconnect the wires, having previously photographed the connection diagram, and remove it altogether;

The bolts that secure the top cover of the body of the vertical SMA Indesit are located behind the control panel.

Unscrew the bolts and remove the cover.

This way you can remove the lid of the Indesit vertical washing machine.If the work is not completed and you need to continue disassembling the machine, then we will tell you what to do next.

Further disassembly

So, how to disassemble the Indesit “vertical”? The removed housing cover will provide access to the remaining elements of the washing machine. We’ll figure out how to completely disassemble the machine, and you, depending on the malfunction, will determine at what stage of the action you should stop. The disassembly process for the Indesit vertical machine will be as follows:

remove the fill valve. To do this, release the clamps securing it, disconnect the wiring and press the fastening latch;
Unscrew the bolts holding the side panels of the machine, remove the walls of the case and put it aside;
Unscrew the screws securing the front panel of the machine, and remove it. After dismantling the walls of the case, access to all components of the “vertical” will open;
disconnect the wires attached to the tank;

For most models of vertical Indesit washing machines, the tank cannot be removed from the body, so the same bearings will have to be repaired on site.

pull the drive belt off the pulley;
disconnect the heating element wires, loosen the nut and press the central bolt inward;
remove the heating element from the tank;
remove the engine by unscrewing the mounting screws and pulling out the chips;
To dismantle the pump, release the clamp on the pipe and drain hose. Remove the pump from its seat by rotating the element from right to left, or by unscrewing the mounting bolts.

Be prepared for water to flow when you remove the drain pump from the system. Therefore, prepare a dry cloth or small container in advance. This way the “vertical” will be disassembled and you can fix the damage.

If the cover needs to be repaired

In some cases, repairs require disassembling the lid of the Indesit washing machine. Disassembling the element is quite simple. Place the cover on a flat surface and follow these steps:

pull out the powder receptacle;
press the latch, remove the button;
unscrew two bolts;
turn the lid over, take out the handle;
release the latches around the perimeter of the door;
divide the panel into two parts.

By disassembling the cover, you can repair or replace failed elements. It is also a good idea to clean the part from debris, dirt, plaque, and inspect the components for corrosion. Assembly is carried out in reverse order.