How to open the top cover of the Ardo washing machine?

In most cases, you can fix the Ardo washing machine yourself without calling a specialist. To do this, you need to have a general understanding of the structure of the machine, know where which nodes are located, what this or that element is responsible for. To get to the required part and carry out repairs, you will have to partially disassemble the case. Let's figure out how to remove the top cover of the washing machine, what tools are needed for this.

Removal in three movements

In fact, “opening” a washing machine is very simple. In the process of removing the “top” you only need a screwdriver or a regular screwdriver. Before disassembling the housing, be sure to turn off the power to the equipment and turn off the water supply valve. Next you need to move the equipment away from the wall, so it will be more convenient to work. Now nothing interferes with dismantling the top cover of the Ardo washing machine. The algorithm of actions is as follows:

• go around the washer;
• Unscrew the two screws that hold the “top” of the housing. The bolts are located under a small protrusion, in the right and left corners;
• Grab the top panel and pull it towards you. The lid should move just a couple of centimeters;
• remove the cover and set it aside.

This will complete the process of removing the top panel. You can begin diagnosing the Ardo washing machine and making the necessary repairs.

If you cannot move the cover, do not try to pry it off with a knife or other sharp object - this may damage the housing.

When the “top” does not budge, the panel is likely jammed. You will have to “stir” it by pressing on the lid from different sides. You can lightly tap it with a mallet.It is important not to overdo it and damage the case. This is how you can remove the top cover on Ardo washing machines. Using this algorithm, it is easy to open many modern models of other brands - the principle of dismantling remains unchanged.

What kind of repair is this needed for?

If you want to maintain and repair the “home assistant” with your own hands, you will have to understand how to disassemble its “shell”. The need to remove the top cover arises in almost any breakdown of an automatic machine. We'll tell you which parts and components can be repaired or replaced if you dismantle this housing panel.

After disconnecting the “top”, access to the inlet solenoid valve will open. The need to check the part arises if water does not enter the machine, or too much liquid is poured. The element is located in the right corner, next to the back panel. By removing the cover, you can test the coil and other parts of the mechanism. The sensor can also be completely replaced if required. If the powder is not easily washed out of the cleaning agent cuvette, it is worth checking the dispenser pipe. By removing the “top” in the manner described, you can clean the tube. It will also be easy to replace the part if necessary.

Another element located under the top panel is a pressure switch. The level sensor measures the amount of water in the tank and sends a signal to the “brain” when it is necessary to start or stop drawing liquid or drain the soap solution. By removing the cover, it is easy to check the serviceability of the element and, if necessary, replace it. There is a counterweight under the cover. This is a concrete block that provides stability to the Ardo washing machine. This part breaks extremely rarely, but if the weighting material is damaged, you can also repair it by removing the “top”.

After removing the top cover, access to the main control module of the Ardo washing machine will open.

Removing the cover is necessary if you need to remove the tank. True, in such a situation you will have to not only remove the “top”, but also the back panel, the front wall, and disconnect many internal parts from the plastic container: heating element, motor, drain pump, pipes, etc. However, the disassembly procedure begins from the top part. Therefore, the ability to remove the “top” of the case will be useful to users in many situations. This is a kind of starting point for repairs of varying complexity.

Reader comments

• Share your opinion - leave a comment